CARBOMECH CM170
Robust and proven design
High power DC Motor to drill any printed circuit material
High cutting torque at low speed
Extremely high accuracy
TECHNICAL DATA SHEET
| Speed range | 8’000 to 170’000 rpm |
| Motor type | synchronous 3-phase |
| Power output (max) | 650 W |
| Peak torque at shaft | 0,300 N m |
| Voltage at max speed | 200 V |
| Maximum tool diameter |
6,35 mm |
| Routing performance |
below 1.0 mm, stack 1 |
| Cooling water flow | 1,2 l/min |
| Cooling water inlet temp | 20-24 °C |
| Bearing type | air bearing |
| Air pressure to bearings | 6,0 kg/cmq |
| Air consumption | 75 Nl/min @ 6.0 kg/cm^2 |
| Axilal load | 260 N |
| Max. vibration | 1,0 mm/sec RMS |
| Minimum collet torque | 1,5 N m |
| Collet locking style | dead stop |
| Collet type | 4 jaws, standard length |
| Collet actuation pressure | 60 kg/cmq |
| Dynamic runout |
(measured at 18 mm from collet) < 10µm |
| Extended collet maintenance | Rocol MT-ML grease |
| Spindle mass | 3.200 kg |